Beo LX
The BEO LX is an optimized version of the BEO in the same housing. It features Beryllium tweeters and a crossover that is even better tuned and uses only very high quality components. As part of our "It's for Life" policy it is possible to upgrade a BEO to LX standard at any time.
Design
- 3-way modular loudspeaker
- Multiplex enclosure made of Baltic birch, optimally braced and damped
- Air Bass System enables low bass from a relatively small volume with very low distortion and excellent definition
- Transitional crossover for excellent linearity and low energy storage
- Special ball corners and driver arrangements prevent refraction at high frequencies
- Rubberised lacquer finish, also available in high gloss polished on request
Technical data
- Impedance: 4 Ohm
- Efficiency 89dB / 1m / 2.85V
- Power rating: 320W
- Amplifier recommendation : 30W to 500W, transistor or tube
- Frequency response: ( -3dB ) 16Hz - 40kHz
- Linearity : +- 2dB
- Distortion factor at 95dB below 0.5% above 100Hz
- Air Bass tuning: 18Hz
- Transitional crossover with high linearity and low energy storage
- Takeover frequencies : 220Hz, 2.2kHz
- Dimensions : 940mm H, 290mm W, 440mm D
- Weight : 35 kG
- Principle: Modular 3-way loudspeaker with AIR BASS system
Configuration
- Tweeter: 29mm Satori Beryllium diaphragm with powerful neodymium drive. Milled aluminium front with decoupling ring. Rear end with light metal cast cabinet
- 15cm midrange driver with NRSC glass fibre cone. Low moving mass, low losses through foam surround and voice coil on non-conductive carrier. Magnet system with Faraday ring for low intermodulation distortion
- 26cm bass with long linear excursion. Hard, anodized light metal cone. Carbon Dustcap. Large magnet system, FEM optimized
